Franklin Pumps

3200 Series (TM)

Reduced Diameter Submersible Pumps

The 3200 Series submersible pumps are designed so that all parts of the pump end, including the cable guard, fall within the diameter of Franklin Electric’s industry leading submersible 4″ motor. This reduced diameter pump end makes it ideal for installations where the well is considered encrusted or tight in comparison to a standard 4″ well. The 3200 Series also offers a hydraulic stage design optimized for greater water and pressure output when installed at deeper well depths. For details on how to become a registered dealer and receive a 5-year warranty, contact your local distributor.

Key Features:

  • Pump diameter is smaller than a standard 4″ submersible for easier installation in reduced diameter 4″ wells
  • Hex rubber bearing and ceramic shaft sleeve allows sand and abrasives to pass through, virtually eliminating shaft wear and upper bearing failures
  • Improved hydraulic performance for deeper set depths at all horsepower and flow ratingsRemovable spring-loaded check valve
  • Floating stage design allows for maximum efficiency while minimizing the down thrust load that is transferred to the motor
  • Noryl® diffuser and disc with 300 Series stainless steel thrust and eye seal protection for durability and abrasion resistance
  • Celcon® impeller provides high performance to increase pressure output while reducing system losses from friction
  • Stainless steel pump intake screen and stainless steel cable guard
  • Maximum water temperature: 120 °F / 49 °C
  • Powered by corrosion resistant Franklin Electric submersible 4″ motor with lightning protection

More info here

VersaJet (TM)

Built for easy customization, this pump covers a variety of performance needs. With our patent pending nozzle replacement system and a small Allen wrench (included), the internal nozzle can be replaced with any of the three nozzles supplied to provide standard performance, high pressure, or high flow.

Key Features:

  • Patent Pending “Quick-Change” jet nozzle replacement system
  • Noryl® impeller with stainless steel insert, diffuser, jet nozzle and venturi
  • Heavy-duty cast iron case
  • Ceramic mechanical shaft seal
  • Floating stainless steel eye seal
  • A.O. Smith dual voltage motor: 115 or 230 V
  • Pressure gauge port
  • Pressure switch installed
  • Built-in drain plug
  • Handles water temperatures up to 120 °F and shut-off pressures up to 90 psi
  • 1” FNPT discharge, 1.25” FNPT suction
  • UL778 approved for indoor or outdoor use

More info here